- 7 -
Using the large
and
buttons on the front panel of the device, set the the cur-
rent day (Monday
MON
; Tuesday
TUE
; Wednesday
WED
, etc.). Press the “
DAY
” button
again. At this time the contraction indicating the day stops flashing and becomes visible
continuously while the abbreviation indicating the hour will flash on the display. Using
the large
and
buttons on the front panel of the device, set the hour value
of the current time. Press the “
DAY
” button again. At this time the numbers that indicate
the hour stop flashing and become visible continuously, while the numbers indicating the
minute will begin flashing. Using the large
and
buttons on the front panel of
the device, set the minute value of the current time.
When you wish to continue modifying the settings, please press the “
DAY
” button again.
If you wish to finish settings, confirm them by pressing the “
SET
” button. At this point
adjusted data are recorded and the device goes back to the main screen (if no buttons
are pressed for at least 15 seconds, the settings are automatically confirmed and the
device goes back to the main screen).
2.3 Switching between the heating and cooling mode
There is a possibility to easily switch between the heating and cooling mode of the
thermostat. The output terminals of the receiver unit
NO
-
COM
and the zone outputs are
turned on below the set temperature in heating mode and above the set temperature in
cooling mode. (Taking the switching sensitivity into account).
