- 26 -
10. TUNING THE COMPUTHERM Q8RF (TX) THERMOSTAT
AND THE RECEIVER UNIT OF THE COMPUTHERM Q5RF/
Q8RF THERMOSTAT AND/OR THE COMPUTHERM Q1RX
SOCKET TOGETHER
10.1
COMPUTHERM
Q8RF (TX)
-
COMPUTHERM
Q5RF/Q8RF
If you would like to use the
COMPUTHERM
Q8RF (TX)
thermostat to complement the
COMPUTHERM
Q5RF
multi-zone thermostat, then follow the tuning steps described
in
Section
7.2
of the manual of the
COMPUTHERM
Q5RF
thermostat or to complement
the
COMPUTHERM
Q8RF
multi-zone thermostat, then follow the tuning steps described in
Section
10.2
of the manual of the
COMPUTHERM
Q8RF
thermostat.
10.2
COMPUTHERM
Q8RF (TX)
-
COMPUTHERM
Q1RX
Press the “
ON/OFF
” button of the
COMPUTHERM
Q1RX
socket and keep it depressed
(for approximately 10 seconds) until the green LED starts flashing. After this, press the
“
SET
” button of the thermostat and keep it depressed then press the “
DAY
” button (for
approximately 10 seconds) until the green LED on the socket/sockets stops flashing.
After tuned together, the thermostat controls the socket according to the set temperature-
program. After receiving the “on” signal from the thermostat, 230 V AC, 50 Hz mains
voltage appears on the output socket/sockets of the
COMPUTHERM
Q1RX
device.
For more information of tuning, refer to the operating instruction of the
COMPUTHERM
Q1RX
socket.
