Quanta Computer QuantaMesh, User Manual

Page: 776 / 1020

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands 776
Syntax
set local-preference <value>
no set local-preference
Default Setting
None.
Command Mode
Route Map Config
Parameter
value: A local preference value, from 0 to 4,294,967,295 (any 32-bit integer).
6.10.2.20 set metric
To set the metric of a route, use the set metric command in Route Map Configuration mode. This
command sets the Multi Exit Discriminator (MED) when used in a BGP context. When there are multiple
peering points between two autonomous systems (AS), setting the MED on routes advertised by one
router can influence the other AS to send traffic through a specific peer.
To remove a set command from a route map, use the no form of this command.
Syntax
set metric <value>
no set metric
Default Setting
None.
Command Mode
Route Map Config
Parameter
value: A metric value, from 0 to 4,294,967,295 (any 32-bit integer).
6.10.2.21 clear ip prefix-list
To reset IP prefix-list counters, use the clear ip prefix-list command in Privileged EXEC mode. This
command is used to clear prefix-list hit counters. The hit count is a value indicating the number of
matches to a specific prefix list entry.
Syntax
clear ip prefix-list [[prefix-list-name] [network/length]]