Quanta Computer QuantaMesh, User Manual, Page: 625 / 1020

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 625
5.26.2.5 ip name-server
This command specifies the address of one or more domain name servers to use for name-to-address
resolution. There are maximum 6 entries for IPv4 and 6 entries for IPv6 in the Domain Name Server
Table.
Syntax
ip name-server <ipaddr>
no ip name-server <ipaddr>
< ipaddr > - IP address of the Domain Name Servers.
<no> - Remove the corresponding Domain Name Server entry from the table.
Note - The listed name servers are queried in the specified sequence until a response is received, or
the end of the list is reached with no response.
Default Setting
None
Command Mode
Global Config
5.26.2.6 ip name-server source-interface
This command specifies the source address of dns client to use for name-to-address resolution.
Syntax
ip name-server source-interface {<slot/port> | loopback <loopback-id> | tunnel <tunnel-id> | vlan
<vlan-id>}
no ip name-server source-interface
<slot/port> - Specifies the interface to use as the source interface.
<loopback-id> - Specifies the loopback interface to use as the source interface. The range of the
loopback ID is 0 to 7.
<tunnel-id> - Specifies the tunnel interface to use as the source interface. The range of the tunnel
ID is 0 to 7.
<vlan-id> - Specifies the VLAN interface to use as the source interface. The range of the VLAN ID is
1 to 4093.
<no> - Remove the corresponding Domain Name Server entry from the table.
Default Setting
None