quadient DS-200iQ, Manual, Page: 207 / 231

Ambient Light
Although the machine may operate in sunlight, it is not designed for use in direct
sunlight, or where sunlight is exposed to the machine through windows or skylights.
Light-sensitive sensors within the machine can be affected in these conditions, therefore
the following is recommended by the manufacturer:
• Position the machine out of direct sunlight when installing.
• Protect the machine from direct sunlight using blinds or similar blocking devices.
If the machine can only be located where it may be exposed to direct sunlight, then
please contact your local Technical Support Engineer, who may be able to advise on
the use of blocking material on the inside of the Perspex cover where necessary.
Important Notes
• All stationery should be allowed to acclimatise near the machine for at least 24
hours before use to prevent rapid absorption of moisture in the material, or
condensation forming on the machine. Failure to acclimatise the material may
cause pre-gumming of envelopes or otherwise impair machine performance.
• The machine will function with humidity levels lower than 30% RH, but high levels
of static may be generated, impairing machine performance.
• The machine will function with humidity levels higher than 80% RH, but moisture
absorption into the material may impair machine performance.
• Condensation must not be present under any circumstances.
• The machine will function at temperature levels above 28 deg C (82 deg F) and
below 18 deg C (64 deg F). However, temperature levels outside these limits may
impair the machine performance.
• Material processed directly from laser printers may have high levels of static
causing material to stick together. If double feeding occurs, then Hi-Grip
separators may be required - contact your local Technical Support Engineer for
further assistance.
8
Technical
Specifications
205
| Page 205 | May-29-2020 11:33 |