quadient DS-200iQ, Manual, Page: 143 / 231

3. Make any necessary adjustments as required. Depending upon which unit is
selected, the available options for fine tuning are as follows:
Collating
- Collate Pkt. Adj (0.1mm) - Adjusts the width of collate pocket guides in
increments of 0.1mm.
- Adjust Pawl Pause Pos - Adjusts the pause time after each insertion Increase
the number if pawls start before previous pack has cleared.
- Collate Slowdown - Select Not on Last Form for thick packs if the final
document in the pack does not feed fully into the collate pocket.
Envelope Insertion
- Fingers Adj (0.1mm) - Adjusts the overall width of insert fingers in increments
of 0.1mm.
- Adjust Envelope Stop (mm) - Adjusts the stop position for insertion.
Select ‘ + ’ to adjust towards the exit in increments of 1mm.
- Finger Sequence - Adjust accordingly if envelopes are not opening properly.
- Insert in Env Position (mm) - Adjusts the pack insertion into the envelope.
Select ‘ + ’ to adjust past the envelope flap crease in increments of 1mm.
- Envelope Blower - Adjusts the opening of the envelope.
Select High for thick packs, or Low for single sheets or thin packs.
Wetting and Sealing
- Seal Time (ms) - Adjusts the time (ms) the envelope ejects after sealing.
- Adjust Wetter Start (mm) - Adjusts where the wetter beam starts.
Select ‘ + ’ to adjust the start point towards insertion area in increments of
1mm.
- Adjust Env Seal Pos (mm) - Adjusts the seal position of the envelope.
Select ‘ + ’ to adjust the position of the envelope further in towards the seal
rollers in increments of 1mm.
- Adjust Env Reverse Pos (mm) - Adjusts the envelope forward travel after
wetting, before reversing into sealing rollers.
High-windowed envelopes should be set b20mm to
+50mm.
Select ‘ + ’ to adjust the envelope further into output rollers, towards the exit
in increments of 1mm.
Miscellaneous
- Linear Speed - Adjusts the speed of the Insert Head to the filled envelope
path only.
Select a lower speed if packs are not being fully inserted (e.g. long packs).
- Env Conveyor Drive Delay - Adjusts the time delay of envelopes on the
conveyor before the conveyor switches back on.
Select a higher number if envelopes are ‘bunching’.
4. Press Ok once the desired settings have been made.
5
Operator
Instructions
141
| Page 141 | May-29-2020 11:33 |