quadient DS-200iQ, Manual, Page: 17 / 231

Output Conveyor Components
Output Conveyor is an output device intended for use with a Sorter, Franker, Envelope
Printer, and or Inserter to provide a means of receiving filled envelopes prior to hand
removal for subsequent further handling, and may be fitted in two possible orientations.
Speed of the Output Conveyor can be adjusted within IMOS for the relevant job, and
batches can be ‘jogged’ to provide a gap between each batch.
The Output Conveyor can be attached to the Inserter in two orientations:
• Angled 90º to the Inserter in the direction of the operator (default orientation)
• In-line with the Inserter
Adjustable Backrest
Adjustable Backrest allows envelopes to stack up against it once they reach the end
of the conveyor, and may be adjusted to suit the required amount of tilt.
Output Sorter Components
Output Sorter is an output device and receives mail-pieces from an Inserter and directs
them to two or more output paths, e.g. an Output Conveyor. Operation of the Output
Sorter is programmed within IMOS and is job-specific.
Sorter Catch Tray
Sorter Catch Tray is optionally fitted at either exit of the Output Sorter, and receives
the envelopes in a stack to allow subsequent hand removal. It may be adjustable to
suit a variety of envelope sizes.
Turner Components
Turner is an output device that delivers mail-pieces to a franker and turns certain sized
envelopes through 90º in order to correctly orientate them for subsequent franking
operation: mainly applicable to C4 envelopes, and C5 with vertical windows.
Turner can be fitted to an Output Sorter, or on its own. Operation of the Turner is
programmed within IMOS and is job-specific.
2
Introduction
15
| Page 15 | May-29-2020 11:33 |