14
INQLINE SECUREMENT™ SYSTEM INSTALLATION
4. Insert the bolts through the washers, backing plate
(not included but recommended), floor and INQLINE
SECUREMENT™ Retractors to secure them in place (D).
Recommended Torque is 42 FT-LB.
Washers and Bolts not included. ONLY use minimum grade
8.8, M8-1.25x16 Bolts. Bolt length = all material thickness
+ 0.34” (8.64mm). DO NOT exceed this length.
Install INQLINE SECUREMENT™ Retractors towards the front of
vehicle with wire harness compartments facing inward.
5. Mark location for installation and drill holes, then clean
debris. Use 4 screws (not included) to secure the Wall
Control Panel Base to the wall and 2 screws (not included) to
secure the Wall Mount (E).
Install towards the rear of the vehicle on the curb side inside
panel, where it’s easily accessible.
6. Place the Wall Control Panel onto the Base and secure it
with the 2 screws (F).
7. Insert the Thumb Controller Cable into the slot underneath
the Wall Control Panel. Then insert the Thumb Controller
into the Wall Mount (G).
FF
D
E
F
Backing Plate
Wire Harness Compartment
G
Summary of Contents for INQLINE
Page 31: ......