Key Log Go rev 2.6 Page 40 of 58
Buffered Mode
To set the transmitting mode to Buffered:
Press
Ctrl-C
(for Configure)
Enter a number between 2 and 20 for the number of
characters. Press Enter when done. When the number
of characters you type hits this number, the text will
automatically be sent to the rig.
The benefit of this mode is the ability to backspace to correct
text before it is sent to the rig. While this is standard using
PSK31 and a computer, the KLG offers this for RTTY, PSK31
and CW
…without the need of a computer.
To transmit text, type on the keyboard or Key-board. The
characters will appear on the bottom line of the KLG display,
and be sent to the rig when:
1. The number of characters typed reaches the number
set using
CTRL-C
…or…
2.
The Enter key is pressed…or…
3.
Prosign KN
is paddled.
If you see something on the bottom line to change, just
Backspace or tap
FN/BACKSP
to correct it.
When characters are buffered and not yet sent to the rig, the
orange Status LED will be on, indicating so. So, if you are
typing and finish your sentence and the orange LED is on, don’t
forget to press Enter or Key-board
prosign KN
so the last
characters are sent to the rig.
Note: When using a data mode, unplug the cable from the
KX3/KX2/K3/K3s Key jack. Issues have been noted when it is
plugged in while using the ACC1 port on the rig at the same
time.
