QMS PS 410, User Manual

Page: 65 / 288

WARNING!
The printer’s controller board is extremely sen-
sitive to static electricity. If you install accessories that contact
the board, like the cards or memory upgrades, make sure you
discharge any static electricity before handling accessories. Do
this by touching the printer’s metal casing before touching the
accessory. Do not walk across carpet while holding the acces-
sory.
Installing a Feeder Tray
If the feeder tray is already installed and you are only installing a
cassette, skip this section and go to the next one. If not, use the
following procedure.
1. Before installing the feeder tray, disconnect the power cord
and interface cable(s) from the back of the printer.
2. Place the feeder tray on a stable, horizontal surface and remove
the cassette from the feeder tray as shown in figure 4.2.
Fig. 4.2 Remove Tray from Feeder Cassette
Chapter 4
U s i n g O p t i o n a l A c c e s s o r i e s 4 - 3