The command goes into effect immediately when you enter the
parameter.
NOTE: You may use this command as an end-of-file marker. For
example, if you know that you want to exit HP PCL
emulation at the end of a particular job, you may insert
the command at the end of the file and your next file prints
in the desired mode.
Returning All Ports to the ESP Default
If you experience problems either entering or exiting a printer
language, you may return the printer to its default ESP mode by any
one of the following:
1.
Enter the PS Executive Utilities’ Special Menu and choose
“Reset Default Parameters."
2.
Send the following PostScript command if you are in ESP or
PostScript mode:
serverdict begin Ø exitserver
statusdict begin
resettodefaults
^D
3.
Return ports to factory default through the Control Panel using
the following procedure:
a. Turn off the printer.
b. Hold down the TEST/CANCEL and ONLINE/OFFLINE
buttons.
c. Turn on the printer while keeping the buttons down.
Chapter 3
3 - 1 2
S e l e c t i n g P r i n t e r L a n g u a g e s
Summary of Contents for PS 410
