QMS PS 410, User Manual

Page: 55 / 288

Configuring the Parallel Port to PostScript To configure the
parallel port to PostScript mode from the parallel port, send one of
the following commands. Type the file, pressing the ENTER key
after each line.
serverdict begin Ø exitserver serverdict begin Ø exitserver
statusdict begin statusdict begin
1 Ø setdefaultemulation 1 Ø setemulation
^D ^D
Configuring the Parallel Port to ESP To configure the parallel
port to ESP, send one of the following commands. Type the file,
pressing the ENTER key after each line.
serverdict begin Ø exitserver serverdict begin Ø exitserver
statusdict begin statusdict begin
1 2ØØ setdefaultemulation 1 2ØØ setemulation
^D ^D
Configuring the Parallel Port to HP PCL To c onfigure the
parallel port to HP PCL, send one of the following commands. Type
the file, pressing the ENTER key after each line.
serverdict begin Ø exitserver serverdict begin Ø exitserver
statusdict begin statusdict begin
1 5 setdefaultemulation 1 5 setemulation
^D ^D
Configuring the Parallel Port to HP-GL T o c onfigure the
parallel port to HP-GL (optional card), send one of the following
commands. Type the file, pressing the ENTER key after each line.
serverdict begin Ø exitserver serverdict begin Ø exitserver
statusdict begin statusdict begin
1 4 setdefaultemulation 1 4 setemulation
^D ^D
Chapter 3
S e l e c t i n g P r i n t e r L a n g u a g e s 3 - 9