PURSUIT 2865 DENALI, Owner'S Manual

Page: 81 / 175

2865 DENALI
Marine Head
Chapter: 10
INTERIOR EQUIPMENT
10.1 Marine Head System
The 2865 Denali is equipped with a china head and holding tank as
standard equipment. The flush water is supplied by a thru hull fitting
located in the equipment compartment bilge aft of the cabin and a raw
water line. Before using, open the inlet valve on the head and pump to
wet the inside of the bowl. After use, pump to discharge the waste to
the holding tank, then close the inlet valve and pump the bowl dry. The
waste remains in the holding tank until it is pumped out by a waste
dumping station.
Holding Tank
The holding tank is located in the bilge. When the tank is full, it must
be pumped out by an approved waste dumping station through the
“waste" deck fitting or the overboard macerator discharge system..
Monitor the waste level in the holding tank and have it pumped out before it is completely full.
If the holding tank is allowed to overfill, the waste will overflow into the tank vent and then
overboard.
IN MANY AREAS IT IS ILLEGAL TO FLUSH HEAD WASTE DIRECTLY OVER-
BOARD. VIOLATION OF THESE POLLUTION LAWS CAN RESULT IN FINES
OR IMPRISONMENT. ALWAYS KNOW THE LAW FOR THE AREAS IN WHICH
YOU BOAT. NEVER DUMP HEAD OR HOLDING TANK WASTE OVERBOARD
ILLEGALLY.
Holding Tank and Macerator Discharge Pump
When the holding tank is full it must either be pumped out by an approved waste dumping
station through the waste deck fitting or be pumped overboard with the macerator discharge
pump, when legal to do so.
To operate the macerator discharge pump, open the ball valve at the overboard discharge thru
hull fitting. Then activate the macerator switch until the tank is emptied. Release the switch
10-1