PURSUIT 2865 DENALI, Owner'S Manual

Page: 42 / 175

2865 DENALI
12-volt Accessory Switch Panel
PROPER FUSE OR BREAKER PROTECTION MUST BE PROVIDED FOR ALL
12-VOLT EQUIPMENT ADDED. DO NOT OVERLOAD THE ACCESSORY CIR-
CUIT BREAKERS OR OTHER CIRCUITRY THROUGH ADDITIONAL 12-VOLT
EQUIPMENT.
Battery Switches
There are three “ON” - “OFF” battery switches
located on the front of the control module in
the engine compartment. The battery switch
labeled “1” activates the helm panel and wind-
lass. The battery switch labeled “2” activates
the engine. The center battery switch is la-
beled “Emerg Parallel” and connects both
batteries in parallel for extra battery power
while starting the engine, or power to all
circuits if one of the batteries is dead or low.
The VSR module allows both batteries to be
charged by the alternator and prevents the
engine battery from being discharged by accessory use.
Make sure that battery switch 1 and 2 are activated whenever the engine is running to insure that
all 12-volt accessories will operate when they are needed.
Notice: Current is supplied to the automatic float switches for the bilge pumps when the
batteries are connected and
the battery switches are off.
12-volt Accessory Switch Panels
The main accessory switch panel is
located in the starboard side panel at
the helm. Other panels located in the
cockpit activate additional accesso-
ries.
The circuit breakers that protect the
accessories are located in separate
panels in the equipment locker aft of the cabin. The switch panel switches activate relays in
the breaker panels that connect the selected accessory.
4-2
Battery Switch Panel