RLX-FHE, RLX-FHES, RLX-FHS
♦
RadioLinx FH
Reference
Frequency-Hopping Industrial Radio
Page 118 of 151
ProSoft Technology, Inc.
November 25, 2008
Retry Limit (ms):
The transmitting radio will re-send the data as many times
as set if there is an error in transmission. In normal transmission, the
receiving radio "acknowledges" that the data has been received with no
detected errors. If the transmitting radio does not get an acknowledgement, it
will re-transmit until the retry limit has been met.
Use this radio as a Repeater:
If this box is checked, the radio will be act as
a Repeater. If it is unchecked it will not.
Allow radio to Roam:
Allows the radio to search the network for the next
available radio to send the information packet to.
Collision Handling:
Select (check) this checkbox to turn on collision
handling. All radios in the network should be set the same, either on or off.
Collision Handling is not necessary for:
o
A single point to point device network
o
A single master slave device network
o
Any other situation where normally only one device is transmitting at a
time
Collision Handling may be necessary if:
o
Multiple independent device networks are connected to a single radio
network
o
The devices use a peer-to-peer asynchronous protocol
o
Any other situation where multiple devices are regularly transmitting
simultaneously
Configure Via COM Port:
Select (check) this checkbox to use a connection
between the serial port on the configuration PC and the serial port on the
radio, rather than an Ethernet connection, to configure the radio.
15.1.9 Associate Device IDs Dialog Box - Modbus & DNP
The Associate Device IDs Dialog Box opens when you click the Associate IDs
button on the Radio Configuration Dialog Box. Use this dialog box to choose
which device IDs to associate to this radio.
Device ID List:
This is a list of all the devices that you can associate with this
radio.
Select All:
Click this button to select all the items in the list.
Clear All:
Click this button to clear (un-select) all the items in the list.
OK:
Click the OK button to save your selection and close the dialog box.
Cancel:
Click the Cancel button to close the dialog box and discard your
changes.
View All Devices:
Click this button to open the Network Device IDs dialog
box (page 122). This dialog box shows a list of all device networks, radios
and device IDs associated with this radio.
15.1.10
Associate Device IDs Dialog Box - DF1 Half Duplex
The Associate Device IDs Dialog Box opens when you click the Associate IDs
button on the Radio Configuration Dialog Box. Use this dialog box to choose
which device IDs to associate to this radio.
Summary of Contents for RadioLinx FH Series
Page 6: ......
