Reference
RLX-FHE, RLX-FHES, RLX-FHS
♦
RadioLinx FH
Frequency-Hopping Industrial Radio
ProSoft Technology, Inc.
Page 121 of 151
November 25, 2008
Refresh List:
If the list of radios is empty or incorrect, click Refresh List to
populate or update the list of radios.
Get Data:
To view the hardware settings for a radio, select the radio in the
Ethernet Radio List, and then click Get Data.
Done:
Click Done to close this dialog box.
The following fields provide information about the selected Ethernet radio. These
fields are for information only, and cannot be modified.
MAC ID:
The Media Access Control identifier for the selected Ethernet radio.
This is a unique identifier for the radio, which distinguishes it from any other
Ethernet device from any manufacturer.
IP Address:
The Internet Protocol address assigned to the radio.
Subnet Mask:
This defines the network ID and is typically set to
255.255.255.0. All Ethernet devices on a particular network should have the
Subnet Mask set to the same value.
Default Gateway:
This defines the default network that the Configuration PC
will operate on. The gateway is the computer that routes the traffic from a
workstation to the outside network.
Protocol Type:
The encapsulated serial protocol type, configured on the
Radio Properties dialog box.
Port Number:
The encapsulated serial port number, configured on the Radio
Properties dialog box.
Baud Rate:
The encapsulated serial baud rate, configured on the Radio
Properties dialog box.
Parity:
The encapsulated serial parity, configured on the Radio Properties
dialog box.
Data Bits:
The encapsulated serial data bits, configured on the Radio
Properties dialog box.
Stop Bits:
The encapsulated serial stop bits, configured on the Radio
Properties dialog box.
Serial Number:
This is the radio's serial number.
Protocol Version:
The firmware protocol version for the selected radio. This
information may be requested by ProSoft Technical Support for
troubleshooting purposes.
Core Version:
The firmware core version for the selected radio. This
information may be requested by ProSoft Technical Support for
troubleshooting purposes.
FPGA
: the version number of the Field Programmable Gate Array logic in the
radio. This logic determines the hardware characteristics of the radio.
Channel Number:
The configured channel number for this radio. All radios
on the network must use the same channel number.
Radio Address:
The software assigns a unique address to each radio in the
network after the radio is configured. (The user cannot change this
addressing scheme - the address field is grayed-out.)
Transmit Power:
The selected output power in dBm (mW), configured on the
Radio Properties dialog box.
Important:
Maximum output power for radios is controlled by regulatory agencies in the country in
which this radio will be operated. Do not choose a power level that exceeds the maximum allowed
for your country or region.
Summary of Contents for RadioLinx FH Series
Page 6: ......
