Configuration Commands
RLXIC-EH
♦
Intelligent Cellular
User Manual
RadioLinx Intelligent Cellular Ethernet Gateway for HSUPA (3G GSM) Networks
ProSoft Technology, Inc.
Page 83 of 111
May 29, 2009
Z
Reset the RLXIC-EH. In AceManager, this command is performed with the Reset
option on the toolbar.
Tip:
*DATZ=1 will disable Z.
&W
Writes all changed modem settings. If this command is not issued, any modified
values will revert back to their previous values at modem reset. Cannot be
configured in AceManager.
*STATICIP=d.d.d.d
Set the static IP required to be received from the network. If the modem does not
get this IP address from the network, it will reset the internal hardware, and try
again. The default is 0.0.0.0, which allows any IP address from the network.
d.d.d.d=IP address
Example:
AT*STATICIP=192.168.1.23
Caution:
STATICIP does not set the IP address of the modem, it merely tells the modem which IP
address to expect. If the expected IP address is not granted while registering on the cellular
network, the modem will try to register on the network again until it receives that IP address. If your
account is set up for a dynamic IP address, and you set an address for *STATICIP, you may not be
able to register on the network at all because there is no guarantee you will receive the same
dynamic IP address again.
*STATUSCHK=n
Checks if an SMS message has been received by the modem.
n=1-255
: Seconds between checks.
n=0
: Never check.
*MODEMHISPEED
Set the internal serial link speed to the internal (radio) module.
n=0
: 115200 (default)
n=1
: 230400
Summary of Contents for RLXIC-EH
Page 4: ......
