RLXIC-EH
♦
Intelligent Cellular
Configuration Commands
RadioLinx Intelligent Cellular Ethernet Gateway for HSUPA (3G GSM) Networks
User Manual
Page 78 of 111
ProSoft Technology, Inc.
May 29, 2009
Network Negotiation Fail:
Network connection negotiation failed. This is
usually temporary, and often clears up during a subsequent attempt.
Network Ready:
The RLXIC-EH is connected to the 1x cellular network, and
ready to send data.
Network Dormant:
The RLXIC-EHis connected to the 1x cellular network,
but the link is dormant. It will be woken up when data is sent or received.
No Service:
There is no cellular network detected.
Hardware Reset:
The internal module is being reset. This is a temporary
state.
*NETSERV?
The type of service being used by the modem, for example Tech.
*NETCHAN?
The current active channel number.
*NETRSSI?
The current RSSI (Receive Signal Strength Indicator) of the RLXIC-EH as a
negative dBm value.
Tip:
The same information is displayed with the command S202?.
*NETOP?
The current cellular carrier from the modem's firmware version, for example, your
cellular provider.
+ICCID
Subscriber Identity Module ID. .
*NETERR?
The EDGE or GPRS network bit error rate.
*POWERIN?
The voltage input to the internal hardware.
*HOSTMODE?
The current host mode (AT, PPP, UDP, etc.). If the RLXIC-EH is not in AT mode,
telnet into the modem to execute this command.
+RCIQ
Current Cell Info Information. GPRS or EDGE Only.
Summary of Contents for RLXIC-EH
Page 4: ......
