Programma EGIL BM-19070, User Manual, Page: 42 / 80

P r o g r a m m a E l e c t r i c A B
Z P - B M 0 1 E R 0 7 A
4 2
E G I L
Status: O = open
R = resistive
C = close
Example:
Adjusting a rotating transducer
When you use a rotating transducer like a motion trans-
ducer, it is important that it is mounted so that the zero
crossing is not exceeded during an operation. Complete
the following steps:
1. Mount the rotating transducer on the
breaker.
2. Select the MONITOR menu. If a percentage
is not shown in the lower left corner, restart
Egil (turn off/turn on) and select the MONI-
TOR menu again.
3. Gently loosen the transducer from its
holder and turn it until about 50% is shown
on the display. Now the transducer is in the
middle of the measure region which means
that it can rotate almost half way around in
each direction without passing the zero
crossing.
4. Make a measurement.