PROEL PLBR8DJ, User Manual

Page: 24 / 32

24
The Record LED will go out in one second after completion of writing, which
implies you’ve quit from SET-UP menu. If failure occurs, the message “Err” will
appear in the LED Screen.
6. A final caveat: No power outage is allowed during writing.
3.2. Read Menu
3.2. Read Menu 3.2. Read Menu 3.2. Read Menu
In CF Card menu, press
∧∧∧∧
/
∨∨∨∨
button to scroll to “2: rd” readout, then press the
Record button to access Read menu.
1. Repeats steps 1-3 of subchapter 3.1.
2. Press Record button, the message “rEAd” will twinkle in the LED Screen, which
indicates it is reading the CF Card. An important caveat: the original data of the
console, such as programs and scenes, will be overwritten.
3. The message “good” will appear in the LED Screen when this process is
completed successfully.
The Record LED will go out in one second after completion of reading, which
implies you’ve quit from SET-UP menu. If failure occurs, the message “Err” will
appear in the LED Screen.
4. A final caveat: No power outage is allowed during reading.
4. RS 232 Menu
4. RS 232 Menu 4. RS 232 Menu
4. RS 232 Menu
Press Record buttons for three seconds until the Record LED is lit. Press
∧∧∧∧
/
∨∨∨∨
button
to scroll to “4: 232” readout, then press the Record button to access RS 232 menu.
In RS 232 menu, you may have access to Software Update, Data Upload or Data
Download using
∧∧∧∧
/
∨∨∨∨
button. Please refer to under-mentioned for further
instruction.
4.1. Software Update
4.1. Software Update 4.1. Software Update 4.1. Software Update
In RS 232 menu, press
∧∧∧∧
/
∨∨∨∨
button to scroll to “1: SOF” readout, then press the
Record button, the Record LED will flash at intervals and the LED Screen will show
“SOFt” indicating it is ready to receive the updated software on your PC.
Help
Help Help
Help –––– RS 232 connection and Windows configuration
RS 232 connection and Windows configuration RS 232 connection and Windows configuration
RS 232 connection and Windows configuration
To connect to a PC, you will need a serial lap link cable available at any computer
store. A standard RS-232 cable will not work. Connect the RS-232 port on PLBR8DJ
to one of the Serial “ com ” ports on your PC.
You will need a PC running Windows 95/ 98 or higher to connect to PLBR8DJ.
Windows comes with an accessory called Hyper Terminal that can communicate
with PLBR8DJ via one of the “ com ” ports on your PC. Determine which of your “
COM ” ports is available. COM 1 is generally used for the
mouse so it is always advisable to connect your PLBR8DJ to COM 2 on your PC.
You must first configure Hyper Terminal to work with PLBR8DJ. Start the Hyper
Terminal program by clicking on “Start” in Windows then “Programs” then
“Accessories” then “Hyper Terminal” then “Hypertrm”. If for some reasons Hyper