PROEL PLBR8DJ, User Manual

Page: 22 / 32

22
1.5. Deletion of Programs 1.5. Deletion of Programs 1.5. Deletion of Programs 1.5. Deletion of Programs
To delete programs, please follow undermentioned procedures:
1. Be sure you are in Record mode. Select a program out of 4 Program buttons, the
Program LED will flash at intervals and the LED Screen will read “ st00 ” .
2. Press and hold down the Program button.
3. Press Delete button while holding the Program button, all LEDs will give a brief
flash indicating you’ve deleted the program successfully.
4. Press Record button for three seconds to quit from Record mode, the relevant
Record LED will go out.
2. Setup Menu
2. Setup Menu 2. Setup Menu 2. Setup Menu
Press Record buttons for three seconds until the Record LED is lit. Press
∧∧∧∧
/
∨∨∨∨
button
to scroll to “2: Set” readout, then press the Record button to access Setup menu.
In Setup menu, you may have access to Assign, Blackout Delay or Display Shift
using
∧∧∧∧
/
∨∨∨∨
button.
Please refer to under-mentioned for further instruction.
2.1. Assignment
2.1. Assignment 2.1. Assignment 2.1. Assignment
In Setup menu, press
∧∧∧∧
/
∨∨∨∨
button to scroll to “1: ASS” readout, then press the
Record button to access Record mode, “C1:L1” appearing in the LED Screen
prompting you to start assignment.
1. Select a fixture or a group of fixtures.
2. Press
∧∧∧∧
button to select channels 1-8 or Pan/Tilt of this console, the LED Screen
will show C1/C2/ C3/ C4/ C5/ C6/ C7/ C8/ PA/ TI accordingly.
3. Select the destination channels of fixture using
∨∨∨∨
button, the LED Screen will
show L1/ L2/ L3/L4/ L5/ L6/ L7/ L8 accordingly. Please bear in mind that every
fixture channel (L1-L8) SHOULD NEVER occupy more than one console channel (C1-
C8), in a nutshell, the fixture channels should be one-to-one assigned to the
console channels.
4. Pan/ Tilt should be assigned before you can use the Joystick to control Pan/ Tilt
movement of fixtures. C1-C8 of the console can be used to assign Pan/ Tilt, be sure
Pan/ Tilt MUST NOT be assigned to the same channel.
5. Press Record button. If the assignment is OK, all LEDs will flash briefly indicating
you’ve succeeded in assignment and the LED Screen will read “ good ” and then go
back to “C1:L1” for another assignment. If there is something wrong with the
assignment, the LED Screen will read “Err” and then return to “ C1:L1 ”.
6. Repeat steps 1-5 to go on with assignment of next fixtures.
7. Press Record button for three seconds to quit from Record mode, the relevant
Record LED will go out.