probst 52400043, Operating Instructions Manual

Page: 110 / 233

Operating Instructions
SH 2500-UNI-B
Maintenance and care
28 / 32
V7 GB
10.2 Maintenance intervals
The yearly inspection must be performed by a qualified specialist.
Interval
Daily Weekly Monthly Every
six months
Yearly
Inspect safety features
(see chapter Sicherheit)
:
•
Vacuum gauge
•
Check that warning light flashes at correct
underpressure/overpressure values
•
Visual inspection of load securing chain 1)
X X
Inspect vacuum filter and replace if necessary X X
Gasoline motor (see also separate operating instructions)
Inspect V-belt, replace if necessary X
Replace V-belt X
Check oil fill level (oil dipstick) X
Change oil X
Inspect air filter X
Replace air filter (more frequently in dusty
environments) X
Inspect spark plug X
Replace spark plug X
Vacuum pump (see also separate operating instructions)
Replace the oil and oil filter every 500 to 2000
operating hours and at least every 6 months (oil
quantity 1.5 l, oil type: see separate operating and
maintenance instructions for the vacuum pump) X
Are the vacuum hoses in good condition (not brittle, not
kinked, no worn sections and no leaks)? X X
Are all connections (hose clamps, etc.) tight? X X
Are type, load capacity and warning signs in a complete and
legible condition? X
Are the operating and maintenance instructions available
and are operators familiar with them? X
Check all load-bearing parts (e.g. suspension) for
deformation, wear or other damage. X
Clean suction plate / Inspect for cracks,
evenness of sealing lip, etc. Replace if necessary
X X
Has the test label been updated? X
General condition of the device X
Leak test X X
Draining the condensation water X X
Condition of load securing chain 1) X
1)
Once the load has been held by the load securing chain, the load securing chain must be properly tested and replaced
if necessary. Damaged load-securing chains must not be used any further!!