Usage instructions BUDDY 4all & classic
13
Figure 1: 2-slot wheel plate for rear seat height
adjustment (view from outer side of product, drive
wheel removed)
Figure 2:
2-slot wheel plate for rear seat height
adjustment (view from inner side of product)
In order to adjust the seat height at the rear,
first remove the drive wheels via the quick
release axles (see chapter 21.1), so that you
have direct access to the wheel plates. Now,
there are the following options.
17.1.1 Mounting the drive wheel bushing
in the other wheel plate slot
If the drive wheel bushing is initially
mounted in the lower slot of the wheel
plate, the rear seat height can be
reduced
by 3 cm
by mounting it in the upper slot.
If the drive wheel bushing is initially
mounted in the upper slot of the wheel
plate, the rear seat height can be
in-
creased by 3 cm
by mounting it in the
lower slot.
Figure 3: Changing the seat height at the rear by
moving the drive wheel bushing in the wheel plate
slots
Figure 4: Outer steel locking nut and drive wheel
bushing (view from outer side of product, drive
wheel removed)
Figure 5: Inner steel locking nut (view from inside of
product)
1. Loosen the inner steel locking nuts (AF
30 mm) on both sides and rotate them
completely off the drive wheel bushing.
2. Now remove the drive wheel bushings
from the wheel plates, insert them into the
other respective slot of the wheel plate and
slide the drive wheel bushings along the
slots of the wheel plates into the correct
tipping point position.Make sure that the
two drive wheel bushings on the right and
Wheel plate (front side)
Wheel plate
(rear side)
Drive wheel bushing
Inner steel locking nut
3
cm
Mounting the drive
wheel bushing in the
other wheel plate slot
Upper slot
of the
wheel plate
Drive wheel bushing
in the other wheel
plate slot
Drive wheel bushing
Lower slot
of the
wheel plate
Outer steel
locking nut
