Usage instructions BUDDY 4all & classic
40
Figure 97: Footrest, folding up to the rear, with
spring latching mechanism, folded up to the rear
If you want to return the footrest to the stand-
ard position again, push it back forwards to the
standard position.
To
adjust the length of the footrest support
tubes
or adapt the lower leg length
, the M6
fastening clamp screws (with polymer dry lock-
ing coating, AF 4 mm) must be unscrewed on
both outer sides of the lower leg tubes. The
lower leg length can now be adjusted along the
notches. Make sure that the same notch is
used on both sides.
A large adjustment range is available for a
shorter lower leg length. If a longer lower leg
length is desired, it can usually be extended by
2 cm with the existing lower leg tube. If a
greater extension is desired, longer lower leg
tubes can be obtained from PRO ACTIV.
Once the lower leg length is adjusted, fix it in
position by inserting the M6 fastening clamp
screws (with polymer dry locking coating, AF
4 mm) on both sides and tightening them to
7 Nm.
Figure 98: Notches and M6 fastening clamp screw
for lower leg length adjustment (view from the rear)
23.5 Divided footrest
Figure 99: Divided footrest, standard position
To
fold up
one of the two footrest parts, grasp
it and fold it up to the side. Moreover, you can
also
turn or pivot the footplate support out-
wards
.
Figure 100: One footrest folded up, option for pivot-
ing outwards marked
Fold up
Pivot or turn outwards
M6 fastening
clamp screw
Notches