Usage instructions BUDDY 4all & classic
42
23.6.2 Angle adjustment of the footplate
arms
The following instructions are intended
for and may only be carried out by a rehabilita-
tion specialist dealer or PRO ACTIV
If the
angle of the footplate arms
is to be
changed, then the M6 fixing screws (AF 5 mm)
need to be loosened further so that the positive
locking on the interlocking serration is re-
leased. Now the angle of the footplate arms
can be adjusted.
Once you have finished adjusting the angle
and the length, tighten the M6 fixing screws
(AF 5 mm) again using 7 Nm tightening torque.
Figure 104: Serration on foot bracket clamps, posi-
tive locking undone
23.6.3 Angle adjustment of the footplate
support
The following instructions are intended
for and may only be carried out by a rehabilita-
tion specialist dealer or PRO ACTIV
The angle of the footplate support plate on the
variable positioning foot support
can be set
by unscrewing the M6 fastening clamp screws
(AF 5 mm) on the lower side of the footrest
support plate. When the angle adjustment is
completed, tighten the M6 fastening clamp
screws (AF 5 mm) again to 5 Nm. This tighten-
ing torque should not be exceeded as higher
tightening torques can damage the clamp.
Figure 105: Foot support can be variably positioned
(view from below)
As an option, it is also possible to choose a
footplate support
that can be
folded up to-
wards the rear
. If the angle of these is to be
adjusted, in addition to the M6 fastening clamp
screws (AF 5 mm) on the footrest support
plate, the M6 fastening clamp screws (AF
4 mm) of the footplate stops must also be
loosened. Now the angle of the footplate sup-
port and the footplate stops can be adjusted.
Then tighten the M6 fastening clamp screws
(AF 5 mm) on the footrest support plate so that
the footrest support plate with the footplate
support can be rotated around the tube. De-
pending on the requirements of the wheelchair
user, this tightening torque corresponds to a
guide value of 3 Nm. The M6 fastening clamp
screws (AF 5 mm) on the footrest support plate
must be secured with screw locking fluid. The
M6 fastening clamp screws (AF 4 mm) on the
footplate stops are tightened with 11 Nm.
Figure 106: Footplate support folding up towards the
rear, folded up
M6 fastening clamp
screws on the
footplate stops
Footrest support plate
Interlocking serration with
positive lock released
Footrest
support
plate
Footplate
support
M6 fastening
clamp screws on
the footrest
support plate