8913204
Gas Pressure Washer
V1.0
18
For technical questions call 1-800-665-8685
6. Remove the garden hose from water inlet of pressure pump and
seal the pump’s inlet and outlet.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for
electronic devices, batteries, oil or other toxic liquids.
Do not drain hydraulic oil into the sewer system or dispose in an
uncontrolled location. Hydraulic fluid may take more than a year to
breakdown in the environment and the ingredients may still be toxic.
Contact your local municipality for proper disposal instructions or locations
IMPORTANT! DO NOT pollute the environment by allowing
uncontrolled discharge of waste oil.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not
function properly or parts are missing. If unable to do so, have a
qualified technician service the tool.
Consult the Engine manual to troubleshoot engine issues.
PROBLEM(S)
POSSIBLE CAUSE(S) SUGGESTED SOLUTION(S)
No pressure
or Low
pressure.
1. Low water supply.
2. Nozzle obstructed.
3. Water filter screen
obstructed.
4. Defective thermal
relief valve.
5. Air in hose.
6. High pressure hose
too long.
1. Water supply must be 2.5 GPM @
20 psi.
2. Clean nozzle of debris.
3. Remove and clean filter.
4. Replace the thermal relief valve or
have a qualified technician repair it.
5. Stop engine and water source.
Disconnect water source from
pump inlet and turn water source
to ON to remove all air from hose.
When steady stream of water is
present, turn water source to OFF.
Re-connect water source to pump
inlet and turn on water source.
Squeeze trigger to remove
remaining air.
6. Use hose under 100 ft.
