Pro-face Pro-face ST Series, User Manual

Page: 43 / 131

ST Series User’s Manual
3-2
3.1 Installation
3.1.1 Installation Procedures
Follow the steps given below when installing the ST.
Check the Installation Gasket’s Seating
It is strongly recommended that you use the installation gasket, since it absorbs vibration in addition to
repelling water.
Place the ST on a level surface with the display panel facing downward. Check that the
ST’s installation gasket is seated securely into the gasket’s groove, which runs around the perimeter of the
panel’s frame. For details about installing the gasket, refer to
SEE
8.1.2 Installation Gasket Check/Replacement (Page 8-2)
• Before installing the ST into a cabinet or panel, check that the installation
gasket is securely attached to the unit.
• A gasket which has been used for a long period of time may have scraches or dirt
on it, and could have lost much of its dust and drip resistance. Be sure to change
the gasket periodically (or when scratches or dirt become visible).
• Be sure to use gasket model ST400-WP01
• Be sure the gasket's seam is not inserted into any of the unit's corners, only in
the straight sections of the groove. Inserting it into a corner may lead to its even-
tually tearing.
• To ensure the installation gasket’s maximum level of moisture resistance, be
sure the gasket's seam instead as shown into the panel's bottom face.
Rear face of ST
Installation
Gasket