38
9. All grades must be an A or B.
10. Verify that the failure is not due to print quality, ribbon wrinkle, smudging or a bad ribbon. If the error is due to
poor print quality, correct the problem and try printing again.
Restoring the Printer Back to Normal Operation
1. Power Off the printer and remove the Ethernet cable from the right side of the ODV and remove any special
labels that were used to do the Field Calibration.
Install the required media and ribbon used to print labels and power On the printer. If required, configure the T8 to
print mode transfer, see below:
Handling
Print Mode
=
Transfer
2. Place the Peel/Tear door assembly in the operating (Up) position,
3. Reinstall the covers on the right and left sides of the ODV2D-V2.
4. Insert the plastic round cap into the center-line adjustment hole on the top of the ODV2D-V2.
