25
Print Speed Limits
The print speed limits of 2-10 IPS are based on steady paper motion and the ability of the ODV2D-V2 camera system to
gather and process the data effectively in real-time.
No higher than 8 IPS is recommended.
Print Bullseye Pattern
Peel/Tear Door Assembly
IMPORTANT The door on the ODV2D-V2 Peel/Tear Door Assembly must be in the CLOSED position when doing
any Field Calibration
adjustments using the “Bullseye” pattern
.
Figure 27:
Close Peel/Tear Door Assembly
Navigating Control Panel
to Print “Bullseye”
Unlock Control Panel
1. Press PAUSE
key to take printer OFF-LINE, panel will display
.
Note: If C/P has been already un-locked,
skip
to
Select “Bullseye” pattern
now.
2. Press UP
and DOWN
keys on control panel simultaneously and control will display:
“
ATTENTION
”
“ENTER
SWITCH”
“UNLOCKED“ OR “LOCKED”
If LOCKED, then press again to UNLOCK.
Select “Bullseye” Test Pattern
1. Press the ENTER
key control panel will display
.
2. Press RIGHT ARROW
key until ODV2D-V2 menu
is selected.
3. Press the ENTER
key and the following will be displayed
.
4. Press the DOWN
key to select Diagnostic
.
5. Press the ENTER
key and the following will be displayed
.
6. Press the DOWN
key
until “Print Bullseye” is selected
.
