14
3. Loosen the 3 small
Locking Cap Screws
by turning each one 1/2 turn CCW (Counterclockwise) using a 2.5mm
hex key.
Figure 17:
ODV2D-V2 Locking Screws
NOTE:
The Large Cap Screw torque value is factory set
. DO NOT TIGHTEN OR LOOSEN THIS SCREW
. The screw
captures a compression spring that provides tension between the ODV2D and the mounting bracket, preventing
the ODV2D from moving freely when the small locking screws are loosened.
4. Then while holding the square in place (See Figure 16),
adjust
Setscrew
‘A’
CW using a 2mm hex key to move
the ODV2 forward or CCW to move it back until each edge of the square is flush against the ODV and the
mounting bracket.
Figure 18:
ODV2D-V2 Adjustment Setscrew A
NOTE:
Do not tighten any of the locking screws at this time. You will be instructed to do so in a later step.
Small Locking Cap Screws
Setscrew
‘
A
’
’
Large Cap Screw
DO NOT TOUCH
