Primera CX1000, Operator'S Manual

Page: 8 / 54

4 Unpack and Assemble
5. Locate the rewinder (right side) chuck, the label guide disc with the three interior holes, the
rewinder, the loctite and the 3mm allen wrench. The rewinder has a longer dancer arm and no
6-pin ports on the back.
6. Assemble the Rewinder. See Figure 2.5.
A. Partially remove the two set screws on the
chuck so that approximately ½ inch (1 cm)
is exposed.
B. Place two drops of loctite on each set
screw.
C. Reset each screw until it is flush with the
outside of the chuck.
D. Peel off the protective wrap from the label
guide disc. Attach the label guide disc to
the rewinder (right side) chuck using two
flat head bolts provided.
E. Attach the chuck to the unwinder (left
side) drive shafts. Line up the holes in the
chuck with the flat edges on the drive
shaft. The holes must correspond with the
flats or the set screws will not hold the
chuck in place.
F. Tighten the set screws using the 3mm
allen wrench. Once they are tight, attempt
to rotate the chuck forward backward
while watching the drive shaft. The drive
shaft should move with the chuck. If it
does not move with the chuck, loosen the
set screws slightly and turn the chuck
until the set screws are even with the flats.
The Loctite will dry in 24 hours.
Figure 2-4.
LOC
TITE
Rewinder
Three Interior Holes
Label Guide Disc
Allen Wrench
Loctite
Rewinder
(Right Side)
LOC
TITE
LOC
TITE
A
B
C
D E
Figure 2-5.