Primera CX1000, Operator'S Manual

Page: 23 / 54

Load Label Stock 19
10. As the printer is preparing to print, get a piece of tape ready. It is best to stand to the right side
of printer with your arms above the rewinder roll. As the stock is ejected from the printer, place
the tape on the middle of the end of the stock.
11. Immediately after the label stock is attached, engage the Rewinder by flipping the Rewinder
Dancer Arm toward the printer until it touches the paper.
Important!
To minimize the slack loop that will be created under the rewinder, it is very important that you
lower the dancer arm immediately after the label stock is taped to the core.
The taping process occurs very quickly so you may not get the label stock attached correctly the first
time you try it. It is important to attach the label stock centered on the core. If the attached label
stock is too far to the right or left the paper may fold over itself and cause an uneven wrap. If you
think the label stock was not attached properly, cancel the print job using the control panel on the
front of the printer.
Figure 4-10.
Warning! Keep loose
fitting clothing such
as ties and shirt
sleeves away from
the rewinder once it
has been engaged.
!
Figure 4-9.
Dancer Arm
Tape