30
Operating and Maintaining the P10 Console
Event
Number
Description of Event
81
Phase C missing (incline control; treadmill only)
82
Phase A or B missing (speed control; treadmill only)
83
Phase C missing (speed control; treadmill only)
85
No dynamic break resistor detected, or dynamic break
resistor is detected as an open circuit, at startup time
(treadmill only)
86
Old console detected on new equipment (treadmill
only)
87
New console installed on older equipment (treadmill
only)
88
Motor temperature too high (treadmill only)
User ID Entry with CSAFE Equipment
This equipment is fully compatible with CSAFE protocols.
When the equipment is connected to a CSAFE master device,
the user is prompted to press ENTER and begin an
identification process. The user ID is displayed as five zeros
and indicates the starting point. The following table describes
key functions while in CSAFE mode.
Table 5. CSAFE access keys
Keys
Function
Number
Keypad
Use the number keys to enter a user ID. Once you
have entered the user ID number, press
OK
to submit
the user ID.
CLEAR
Erases individual numbers in the user ID from right to
left.
OK
Submits the user ID.
Note:
User ID entry is bypassed when the user enters
five zeros. No workout statistics are recorded.
PAUSE
Resets to the Welcome banner.
A message appears on the display and indicates when the
user ID is accepted by the CSAFE master device. Once
program selection is complete, the user can begin exercising.
Summary of Contents for P10
