Precor P10, Operating And Maintaining

Page: 23 / 144

Setting Up the Console
21
Club Parameters
Use the following information to customize the equipment for
your setting.
Note: When you make changes to the club parameters, the
new settings replace the factory default settings.
Safety Code (Treadmill only)
Value: Enabled or Disabled
(Default: Disabled)
When the equipment is shipped from the factory, the safety
code protection feature is disabled. If you enable the safety
code, your users will need to enter a four digit number to
begin their exercise session and start the running belt. The
code is
1 2 3 4 .
Select Language (All Equipment)
Value: English, Deutsch, Espanol, Francais, Netherlands,
Portugues, Rucckijj, and Italiano
(Default: English)
Select your preferred language for the console display.
Note: Programming prompts are not affected by language
selection. The prompts in this section continue to appear in
English.
Select Units (All Equipment)
Value: U.S. or Metric
(Default: U.S.)
The equipment can display measurements in either Metric or
U.S. Standard.
Important: If you change the Unit of Measure on a treadmill, be
sure to check the speed setting to verify that it is correct.