page 18
C
O
M
M
E
R
C
I
A
L
P
R
O
D
U
C
T
S
D
I
V
I
S
I
O
N
22.
Install the lift cover.
Diagram 13. The center holes (see inset) on the lift
cover are used for mounting it to the base of the upright bracket support.
(The two side holes are used for a different product.)
a. Position the lift cover as shown in Diagram 13.
b. Insert the 3/4-inch screw into the mounting hole closest to the ramp and
finger tighten.
c. Insert the 1/2-inch screw closest to the upright support.
d. Tighten both screws with a phillips head screwdriver. Do not overtighten
or you may crack the plastic lift cover.
Diagram 14
Install the side
covers.
Ramp cutout
Side cover
Diagram 13
Install the lift cover.
Center holes in
cover
Lift cover
3/4-inch screw
23.
Install the side covers.
Diagram 14. Proceed with one side at a time.
a. Remove the two 3/4-inch buttonhead screws (E) and 5/32-inch hex key (B)
from the Hardware kit.
b. Grasp one side cover and rotate it so that it slips inside the ramp cutout.
Have your assistant hold it in place.
2
1
Replace screws
from step 21.
1/2-inch screw
Upright support
bracket
3/4-inch buttonhead
screw (E)
