page 16
C
O
M
M
E
R
C
I
A
L
P
R
O
D
U
C
T
S
D
I
V
I
S
I
O
N
19.
Attach the left and right frame stabilizers.
Diagram 9. Proceed with one
side at a time.
a. Remove four bolts (F) and four washers (G) from the Hardware kit. Place
a washer on each bolt and set the fasteners within easy reach of the unit.
b. Grasp one of the frame stabilizers and align it with the upright support bracket.
Have your assistant hold it in place.
c. Insert the four bolts (F) with washers (G) through the frame stabilizer and
upright support bracket. See Diagram 9.
d. Thread all four bolts and washers until the frame stabilizer is secure. Do
not fully tighten the bolts until after the lower section is attached.
e. Perform steps a. through d. on the opposite side.
Diagram 9
Attach the frame
stabilizers to the
upright support
bracket and base
tube.
Bolts (F) and
washers (G)
Frame stabilizer
Diagram 10
Attach the lower
frame stabilizers
to the base
assembly.
f. Carefully, align the mounting holes on the right and left frame stabilizer with the
base frame holes. Insert four bolts (F) and washers (G) on both sides. Gently
move the stabilizers up and down to get the mounting holes on both sides
properly aligned and then thread the bolts through the unit. See Diagram 10.
g. Alternately tighten the eight bolts with a 9/16" wrench. This helps pull the
rest of the parts into alignment.
Upper section
Lower section
Upright support
bracket
Bolts (F) with
washers (G)
