page 12
C
O
M
M
E
R
C
I
A
L
P
R
O
D
U
C
T
S
D
I
V
I
S
I
O
N
2
Diagram 3
4.
Cut the tie wrap securing the front base tube to the pallet.
Discard the tie wrap.
CAUTION: Grease on the lift screw can stain clothing.
5.
Thread the height adjustor to its lowest position.
Diagram 3, #1 and #2.
Remove the height adjustor from the Hardware kit. Ask an assistant to lift the
front base tube while you insert the height adjustor. Turn the height adjustor so
that the threads appear inside the base tube. Tighten the nut (with a crescent
wrench) when the height adjustor is fully threaded into the front base tube.
6.
Cut the tie wrap holding the plastic grommet.
Diagram 3, #3. Use a wire
cutter (or scissors) to remove the plastic grommet from the cable.
Front base assembly.
Cut the tie wrap that
secures the grommet
to the cable.
Height adjustor
Front base tube
3
Tighten the height
adjustor so that the
nut is secure against
the front tube.
Diagram 4
Insert grommet and
route lift motor cable.
Plastic grommet
Front base tube
1
7.
Insert the plastic grommet.
Diagram 4. Press down on the grommet so that
it snaps into place. Thread the lift motor cable through the grommet.
Plastic grommet
Note that illustrations
1 and 2 do not show the
lift motor that is atop the
front base tube.
Plastic grommet
Lift motor cable
Lift motor cable
