14
15
INSTALLATION OF THE ANALOG LIMIT SWITCHES
Step 1:
With the gate closed, place the magnet holder on the rack, positioned in
front with the REED of the operator. This magnet will act as a closing limit switch.
MAGNET HOLDER
MAGNET HOLDER
REED SUPPORT
Step 2:
Fully open the gate and place the other magnet holder on the rack, facing
forward with the operator REED. This magnet will act as an opening limit switch.
MAGNET HOLDER
REED SUPPORT
Step 3:
Remove the plastic covers to gain access to the board, then operate the
motor and see if the REEDs are shutting down properly. If necessary, invert the MGS
connector on the control board.
After attaching the magnet holders, make final adjustments by moving them to
the right or left, depending on the desired setting.