6
7
TOOLS REQUIREd FOR INSTALLATION
Here are some tools required to install the operator:
PLIERS
SAWING BOW
SOCKET WRENCH
SCREWDRIVER
NUT WRENCH
LADDER
WELDING MACHINE
HAMMER
LEVEL
TAPE MEASURE
FRAME
DRILL
PENCIL
SANDER
TYPICAL INSTALLATION OVERVIEW
ITEM
DESCRIPTION
1
Gate Operator
2
Rack
3
Photocells
4
Safety Edges
5
Pushbutton
6
Flashing light
7
Power supply 230V
ELECTRICAL INSTALLATION
For electrical installation, the network shall contain the following characteristics:
- 230V-50Hz power supply;
The passage of the wiring must be made through conduits between:
- the electrical distribution box and the total disconnect device
- the total disconnect device and the operator supply terminals;
- the control board and the (optional) external pushbutton;
- the control board and the photocells;
The wires used must comply with the local standards. The recommended cable
sizes are listed below:
DZ IND 1.0 BRUSHLESS DC
DZ IND 1.5 BRUSHLESS DC
DZ 2.0 ROBUST BRUSHLESS DC
Cable Section
Maximum Lenght
Power supply 230V
3 x 1,5 mm²
50 m
Photocells
2 x 0,5 mm²
10 m
Safety Edges
2 x 0,5 mm²
10 m
Pushbutton
2 x 0,5 mm²
5 m*
Flashing light
2 x 1 mm²
20 m
*For further distances, please contact technical support.
CARE WITH ELECTRICAL INSTALLATION
To avoid damage to the wiring, it is important that all conductors are properly
attached to the operator. Wiring must be done through conduits, passing internally
through the base of the fl oor, ensuring that none of the wiring conductors are
trapped and damaged.
