Power i-Cruise Dial, Instruction Manual, Page: 33 / 36

Anything is changeless even if it turns or pushes a
dial.
？
Although LED of a dial lights up, in not changing, since attachment
of the harness according to vehicle type may have an error, please
check.
！
Since there is possibility of the loose connection of a speed signal
wire (blue), please redo wiring. Moreover, please connect the speed
signal wire to the wiring diagram according to vehicle type in the
position of a statement.
！
An auto throttle control function is interlocked with speed, and an
accelerator reaction changes. Since an effect is not known in empty
revving up, please run and check.
！
When LED of a dial does not light up, please check all wiring (P9).
Please reconfirm whether there is any mistake in the connector
(seven pins) which connects a main part unit with a power source
wire (white), a ground (black), the harness according to vehicle type,
and a lever especially.
！
Auto‑cruise cannot be started. Or it is canceled
freely.
？
Auto‑cruise cannot be started even if it performs click operation,
when it is not READY mode.
In order to start auto‑cruise, please operate it in the state where a
dial is pushed once and blue LED is blinking.
！
For safety, the resume function by right‑click operation stops operating,
when speed is less than 50 km/h, and it also eliminates a storage speed.
A standard and auto‑cruise are carried out by left‑click operation, and
unless it is less than 50 km/h after that, resume auto‑cruise can be
performed.
！
When you install this product for the first time, please be sure to
perform accelerator study (P14) and study (P18) of speed. Unless it
performs initial study, the auto‑cruise does not operate normally.
！
‑32‑
Troubleshooting
↓next page is followed.