Power i-Cruise Dial, Instruction Manual, Page: 32 / 36

When engine check lamp lights up.
Troubleshooting
？
When you attach this product for the first time, please be sure to
perform accelerator study (P14) and study (P18) of speed.
If this product is used without performing initial study, a check lamp
may light up.
！
Please check that Item number of the harness according to vehicle
type conforms to vehicles in a conformity table.
Parts number 1A, 1B, 1C, etc. have the same connector form, there
is harness in which pin arrangement differs, and if it attaches
accidentally, an engine check lamp will light up.
！
Please check whether direction of the connector of the harness
according to vehicle type is mistaken.
Especially the vehicles side female connector and the harness male
side connector classified by vehicle type may be able to be inserted,
if power is put even if direction of the upper and lower sides is
reversed.
！
When pure ECU is rewritten or you exchange, and when a pure
accelerator is exchanged, since there is a possibility that a check
lamp may light up, please redo study of an accelerator. ！
Please check whether it does not expect and cannot perform study of an
accelerator.
In that case, since a possibility that study of the accelerator is carried
out for the mistaken information is high, study of an accelerator is
performed once again (P14), and please let me learn the right information.
！
When a certain trouble arises while using i‑Cruise Dial, please check
according to the following troubleshooting before judging it as failure of a
product.
Even if it follows troubleshooting, when a problem is not solved, or when
troubles other than the contents shown below occur, please stop use
immediately and consult with a store.
When all LED of a dial has gone out, it is in a power supply OFF
state, and it is the same as the state where the product is not
attached.
Therefore, when a check lamp lights up in this state, please improve
attachment of the harness according to vehicle type.
！
‑31‑