Power i-Cruise Dial, Instruction Manual, Page: 31 / 36

‑30‑
If the minus terminal of a battery is removed, a setup of a clock or
an audio and other setup of an electronic device will be reset.
There needs to be an important setup in a memo and please keep it.
In addition, even if initial setting<accelerator and speed> of i‑
CruiseDial removes the minus terminal of a battery, it is not reset.
How to turn off a check lamp
① Please stop engine and turn off ignition switch.
② Please neglect it about 5 minutes then and remove the cause by
which it seems that the check lamp lit up.
③ Please check that waiting and an engine check lamp do not light up
for 1 minute after starting engine.
④ When an engine check lamp does not go out, please turn OFF ignition,
remove the minus terminal of a battery, and neglect it about 5 minutes.
⑤ Please check that waiting and an engine check lamp do not light up
for 1 minute starting engine.
⑥ When an engine check lamp does not go out by this method,
please consult with a store, a repair shop, etc.
Please refer to troubleshooting from the following page about
the cause which the engine check lamp turned on.
Important
Important