Power i-Cruise Dial, Instruction Manual, Page: 25 / 36

Operation method of auto‑cruise
About the acceleration and deceleration under auto‑cruise
By the following and the method of the
following page, a change of auto‑cruise
speed can be made to acceleration and
deceleration also in auto‑cruise.
Speed (* target speed) goes up 2 km/h at
a time by lifting a hand in the place which
turned the dial to the right until it is
responsive during auto‑cruise.
Speed (* target speed) falls 2 km/h at a
time by lifting a hand in the place which
turned the dial to the left until it is
responsive during auto‑cruise.
Acceleration with an accelerator can be
performed also in auto‑cruise.
After acceleration, if an accelerator is
returned, it will slow down to the original
auto‑cruise speed, and will resume auto‑
cruise.
After acceleration is made to auto‑cruise
the speed after acceleration by canceling
auto‑cruise once and re‑setting it up
immediately with a button.
‑24‑
① Acceleration and deceleration in a dial click
② Re‑setup by accelerator is stepped
It goes up 2 km/h at a time by
one click on the right.
It falls to the left 2 km/h at a time
by one click.
The accelerator is stepped
on and it accelerates.
A cruise is once re‑set up by release &
left‑click, and it is the speed after
acceleration, and is a cruise.
If operation is received, blue LED will
go out for a moment, and will announce you.
If operation is received, blue LED will
go out for a moment, and will announce you.
The thing of the largest valve angle at three,
auto‑cruise control, dial acceleration, and
pedal acceleration, is reflected in actual
acceleration.
Important