27
MA-Di
COMPRESSED AIR AT ITS BEST
SEL2
Standard measured variable for evaluation through
OUT2
:
- Limit value signal or analog signal for flow rate
- Limit value signal or analog signal for temperature
rEF.P
Standard pressure which the measured and display values for flow
rate refer to
rEF.T
Standard temperature which the measured and display values for
flow rate refer to
LFC
L
ow
f
low
c
ut-off
rES
Reset factory setting
8
PROGR PARAMETER SETTING
8.1 Programming
Every parameter setting requires 3 steps:
Select parameter – adjust value – confirm
Press the
Mode / Enter
, key until the
desired parameter
appears in the
display.
Press the
Set
key and hold it.
The current
parameter value is displayed
flashing for 5 s.
After that
, it is
increased
* (stepwise by single pressing
or continuously by holding the key).
Briefly press the key
Mode / Enter
(= confirmation). The parameter will be
displayed again, the new
parameter
value has become effective.
Change further parameters:
Start again with Step 1.
End programming:
Wait 15 s or press the
Mode / Enter
-key
until the current measured value appears.
8 Progr Parameter setting