LOADING INSTRUCTIONS
Take hold of the gum and mint assembly and pull the unit forward until the tray comes to
the stop. To load, push the cover toward the rear of the machine. Lay the gum or mint
packs on their side with the label facing toward the front of the gum and mint assembly.
Each selection has a clear, hinged product ejector which may require adjustment for each
type of product. To adjust this ejector, on each side is a small compression clip. Squeeze
the clips on each side (See figure below), then slide the ejector in or out until the hinge
knuckles are located entirely behind the first product and directly above the second prod-
uct. Release the clips and ensure that the ejector is locked into place.
IMPORTANT:
Before sliding the tray assembly back into the machine, pull the cover
forward over the product and under the retaining clips. Verify that both latches on the
gum and mint assembly are engaged after the tray is pushed back into dispensing posi-
tion.
NOTCHES MUST ALIGN
WHEN ADJUSTING GATE
ASSEMBLY IN ORDER
FOR PRODUCT TO
VEND PROPERLY
GATE ADJUSTMENT
To adjust gate assembly front to rear depress flex-tabs as shown. Adjust gate assembly all
the way forward until gate hinge is directly over the second item to be vended. Adjust
gate assembly to the rear for larger product.
9
Summary of Contents for ULTRA VENDOR 32
