Polyvend ULTRA VENDOR 32, Service Manual

Page: 6 / 53

Shown in views A and B are two properly grounded and polarized wall outlets. One is a
three wire grounded type wall outlet (See View A) and the other is a two wire wall outlet
(See View B) with an adapter in place.
Should the polarity at the wall outlet appear any way other than that shown below, the
outlet should be rewired by qualified personnel.
THREE WIRE
GROUNDING TYPE
TWO WIRE
WALL OUTLET
WALL OUTLET
CIRCUIT GROUND
OR COMMON
VIEW A
GROUND
HOT
CIRCUIT GROUND
OR COMMON
VIEW B
CAUTION: DISCONNECT POWER TO THE VENDING MACHINE BEFORE
REMOVING THE CONTROL BOARD, COIN CHANGER OR WORKING ON ANY
ELECTRICAL COMPONENTS IN THE MACHINE.
* Check to ensure that power is present. ‘Remember when you pull out the sliding
drawer, the safety interlock will shut off the power to the control board. To
re-energize the control board, pull the plunger out on the safety interlock switch
located at the back of the pull out drawer. For the location of safety interlock (See
figure 4 on page 10).
* Test the coin mechanism and coin return assembly to insure smooth operation. If
the operation is not smooth, check to make sure that you have proper alignment of
the changer with the coin return lever.
* Load the coin tubes on the coin changer located in the pull out sliding drawer. It is
very important to fill the 2 5 c 10c and 5c tubes for proper changer payback.
Note: The maximum amount of change a Coinco 9302LF changer will hold is
$38.60; $23 .OO in quarters, $12.70 in dimes and $3.40 in nickels. The maximum
amount of change that a Mars TRC 6010XV will hold is $29.95; $16.75 in quar-
ters, $9.80 in dimes and $3.40 in nickels.
3