Polyvend ULTRA VENDOR 32, Service Manual

Page: 14 / 53

H I G H VOLTAGE POWER SUPPLY
The high voltage power supply is located in the bottom of the machine, on the right hand
side beside the coin bank. The circuit breaker for the 110 volt circuits is located on the
top of the power supply. Also located inside the power supply are the ballast for the
fluorescent light, the step down transformer and the RFI filter. The starter for the fluores-
cent light is located on the right end of the light fixture.
STORAGE COMPARTMENT
The storage compartment is below the product display area and is accessed by opening
the front door. Additional products may be stored in this area. Be sure to leave room for
the delivery compartment when using the storage area.
H E L I X TRAY REMOVAL
Lift up on the front of the tray and pull the tray out to the stop. Allow the tray to tilt down
into the loading position. Unplug the tray harness from the motor distribution board (lo-
cated in the sliding drawer assembly) and set the harness on the tray you are removing.
Lift up on the tray front and pull the tray upward and outward. The tray can now be
removed from the machine for cleaning or service, To install the tray lift up on the front
of tray so that the back of the tray is lower than the front and slide the tray in. Reconnect
the tray harness in the drawer assembly.
NOTE: Because of the wiring configuration of this machine the candy rows must be
rows C and D.
T R A Y HELIX REMOVAL
An individual helix can be removed for cleaning, repair or replacement with a different
pitch whether the tray is in or out of the machine. A helix used with the new snap-in hub
feature can be removed by first grasping the helix close to the hub and pulling firmly on
the assembly toward the front of the tray.
To re-install the helix assembly, note that the snap-in shaft is square shaped, so the helix
must be properly positioned (product kicker in correct position). With the helix correctly
positioned, align the shaft of the hub with the octagon shaped motor drive and push the
helix into place. A positive lock in position will be felt when the shaft is properly inserted
and locked into place.