Polyvend ULTRA VENDOR 32, Service Manual

Page: 5 / 53

CAUTION: DISCONNECT POWER TO THE VENDING MACHINE BEFORE
REMOVING THE CONTROL BOARD, COIN CHANGER OR VALIDATOR OR
WORKING ON ANY ELECTRICAL COMPONENTS IN THE MACHINE.
INSTALLATION
*
*
*
*
*
*
*
*
Remove all external packing material
Inspect equipment for shipping damage, if evident file claim immediately with the
carrier (See shipping procedures).
Remove keys from product dispensing compartment (in small manila envelope),
unlock the service door and remove the shipping cardboard.
Save extra fuses, etc. found in envelope as spare parts.
Check the operation of the service door and locking mechanism. They should
operate smoothly and latch at all three locking plates.
Place machine into position and adjust leveling legs so the machine is level and all
the legs sit firmly on the floor.
Cut the plastic ties holding each tray in position.
Plug service cord into 110VAC source using the three prong grounded plug
provided. If a grounded outlet is not available, use a proper external ground on all
locations.
NOTE: In order to comply with electrical safety regulations and Underwriters Laborato-
ries requirements, all electrical equipment must be properly polarized and grounded. The
Polyvend machine is wired so that it is properly polarized in accordance with the
electrical code. If the wall outlet is wired and grounded properly, then the vending
machine will connect properly.
2