Polyvend ULTRA VENDOR 32, Service Manual

Page: 11 / 53

(OPTIONAL) GUM AND MINT TRAY LOADING
NEW STYLE SLIDE OUT DRAWER ASSEMBLY
The four select gum and mint dispenser is available in kit form or can be factory in-
stalled. All machines are prewired from the factory so you can install the gum and mint
kit at a later date. The harness for the gum and mint assembly plugs into the motor distri-
bution board. This is the same board that the tray harness plugs into. Each selection will
hold up to 15 packs of gum (5 sticks per package) or roll candy up to 4 inches in length.
If a small diameter product of the anti-acid or breath mint type is to be vended it will b e
necessary to use a pair of height adapters for each selection. These height adapters can be
ordered from your local distributor or from the Polyvend Parts Department. There are
two different heights available, the thinner adapter is normally used for anti-acid or breath
mints. The thicker adapter is used for very small diameter products or in some cases very
short rolls or packages of candy or gum. The short product will then go in between the
height adapters and act as a guide to keep them in position.
Each gum and mint assembly uses dividers that can be adjusted for the length of the
product to be vended. They can be moved by pushing the divider towards the rear of the
machine, unhooking the locking tabs and lift the divider upward. Move the divider closer
or farther apart depending on the length of the product to be vended. To lock the divider
in place allow the locking tabs on the divider to slip in the holes provided in the bottom
of the tray and pull the divider towards the front of the machine locking it in place.
NOTE: New style gum
higher.
and mint units installed in machines with serial number 18 11 a n d
8