PRIMARY CABINET COMPONENT INFORMATION
SLIDEOUT CONTROL DRAWER
All electrical components in this compartment are low voltage. Located in this panel are
the validator, the changer, control board (digital readout mounted on control board), 10
volt and 24 volt fuses and the motor distribution board. The 110 VAC transformer, light
ballast and 110 volt circuit breaker are located in the high voltage electrical box mounted
beside the coin bank. Starter for light is mounted on the right end of the light fixture.
Note: The safety interlock switch that turns on the power to the drawer is located in the
rear, as shown in figure 4.
INTERLOCKSWITCH
EIGURE 4
REMOVAL OF SLIDEOUT CONTROL DRAWER
With the service door open, pull the slideout drawer out to the stop. Reach up from t h e
storage area to the rear of the slideout drawer and unplug the harness connection from the
rear of the drawer.
Note:
The slideout drawer may have to be pushed partially closed, in
order to reach the back of the drawer and disconnect the wiring harness. Disconnect the
six tray harness from the motor distribution board. After disconnecting the harness, pull
the drawer to full open position. Remove the four (4) screws from the slide in the center
of the drawer. Two of the screws must be removed through the large hole in the center of
the slide section. Be careful and
DO NOT ALLOW THE DRAWER TO FALL
when
removing these screws. Tilt the drawer out until you can reach the screw mounting the
grounding wire and remove the screw. Lift and remove the drawer from the guides. For
installation of the drawer reverse the procedure.
10
Summary of Contents for ULTRA VENDOR 32
